• monkeyman512@lemmy.world
    link
    fedilink
    English
    arrow-up
    28
    ·
    10 months ago

    If it still has working USB you can hook it up to a $10 raspberry pi with wifi to act as a print server. I can understand if that’s a more ambitious tech project than your ready to take on.

    • u/lukmly013 💾 (lemmy.sdf.org)@lemmy.sdf.org
      link
      fedilink
      English
      arrow-up
      7
      ·
      10 months ago

      There also used to be network printer adapters in the past. For example, the Belkin F8T030 Bluetooth AP. Yes, Bluetooth AP. I’d like something like that just for fun. Perhaps not this one specifically, as it only supports BT-LAP out-of-the-box and requires firmware upgrade for BT-PAN. Good luck finding firmware for a niche product from 2003.

      But anyway, perhaps something like that (the printer part) is still made.

    • pearsaltchocolatebar@discuss.online
      link
      fedilink
      English
      arrow-up
      4
      arrow-down
      1
      ·
      10 months ago

      I’m a systems engineer, so it would be a short project for me. My homelab router could run the print server, but the USB port is currently powering my pi hole.

      I feel like there would be some way to rig an esp32 or similar micro controller to do the same thing (pis can be scarce atm

      • frezik@midwest.social
        link
        fedilink
        English
        arrow-up
        1
        ·
        10 months ago

        Rpi stock issues are well behind us. You can buy them straight up now. Even the 1GB RPi4.

        Esp32 may not have enough RAM to buffer large prints, especially if there’s a lot of graphics. It is possible to give it up to 4MB of external RAM, but that’s still not much.

        Pi Pico can do a 16MB external RAM chip. That’s starting to be adaqute.

        I had an HP 5si for a while with 20MB of internal RAM. It struggled with Postscript printing–could only buffer and print one page at a time. Did fine with HP’s own PDL drivers, though.

        • pearsaltchocolatebar@discuss.online
          link
          fedilink
          English
          arrow-up
          1
          ·
          10 months ago

          I still had some trouble getting the Zero 2Ws, but a lot of sellers still have a limit of 1 per order.

          I’ll probably use my Zero W for the print server once I replace the controller for my snake’s enclosure with a 2.