It’s for bias to the mic. Condenser mics need it to apply bias to one of the leads of the mic so it can amplify the sound before sending it to the input of the card. Some mics don’t require that (self-biased) so in that case, the R pin (middle ring) goes to GND.
Ah, seems you’re right. I didn’t know that. But that seems to be an old way of doing it. I’ve only ever seen 2 contacts on a seperate microphone jack or the 4-contact combined ones in modern laptops.
Regardless, if it doesn’t require the bias pin, the mic is self-biased or biased through another source (use the same wire for the signal to get bias, this is easy, you just use a cap to decouple the signal from the bias).
Microphone is mono They’re wondering why there’s a third contact
It’s for bias to the mic. Condenser mics need it to apply bias to one of the leads of the mic so it can amplify the sound before sending it to the input of the card. Some mics don’t require that (self-biased) so in that case, the R pin (middle ring) goes to GND.
Ah, seems you’re right. I didn’t know that. But that seems to be an old way of doing it. I’ve only ever seen 2 contacts on a seperate microphone jack or the 4-contact combined ones in modern laptops.
http://tuxgraphics.org/npa/condenser-mic-on-usb-sound-card/
The link doesn’t open, says connection refused 🤷.
Regardless, if it doesn’t require the bias pin, the mic is self-biased or biased through another source (use the same wire for the signal to get bias, this is easy, you just use a cap to decouple the signal from the bias).